Microscan MS-810, User Manual

Page: 43 / 144

Operation Menu
MS-810 Industrial Scanner User’s Manual
2-21
2–Menu C
o
n
fig
.
Good Decode Reads
Default: 1
Options: 1 to 31
Allows you to select the number of good reads (from 1 to 31) required per label
before a good decode output.
Note: Be sure to set the value within the determined scan rate for the scanning setup
so that the scanner is capable of scanning a label the required number of times.
New Master Pin
Default: Disabled
Options: Disabled, Enabled
Note: Match Code Type ( page 2-22 ) and a triggered mode ( page 2-16 ) must be set for
Enabled or Sequential for New Master Pin to take effect.
Allows you to momentarily connect pin 12 to ground in order to clear any existing
master label information from memory and allows the next label to be read as the
new master label information.
Number of Labels
Default: 1
Options: 1 to 6
Note: If Number of Labels is set to any number greater than one while Match Code
Type or Continuous Read 1 Output is enabled, Number of Labels will default back to
one.
Note: If using Supplementals option for UPC, see “Supplementals,” on page 2-29
for specific directions on defining Number of Labels.
Allows you to choose the number of different labels that can be read in a single trigger
event. The following conditions apply:
1. Each label must be different to be read.
2. The maximum number of characters in any one label is 64.
3. The maximum number of characters in a single scan line is 384.
4. The maximum number of characters for all labels is 384, including preamble, post-
amble, and all spaces and commas.
5. All noread messages are posted at the end of the data string.
6. If more than one label is within the scan beam at the same time, label data may not
be displayed in the order of appearance.