Microscan MS-810, User Manual

Page: 58 / 144

Chapter 2
2-36
MS-810 Industrial Scanner User’s Manual
2–Menu Conf
ig
.
End of Read Cycle
Causes bar code data output to be delayed until the end of the read cycle.
Noread Message
Default: NOREAD
Options: Up to seven ASCII characters (except NUL)
Allows you to define any combination of ASCII characters (except NUL) up to seven
characters as the noread message. When enabled, and if no bar code label has been
decoded before timeout or the end of the read cycle, the noread message will be transmit-
ted to the host.
Noread Output (enable/disable)
Default: Enabled
Options: Enabled, Disabled
Note : If Noread Output is enabled, the noread message will only output if Bar Code
Output ( page 2-35 ) is also enabled.
Allows you to enable or disable the noread message.
Beeper Status
Default: On Good
Options: On Good, On Noread
A beep is emitted either after each good read of a bar code label or after each noread.
Note: The beep period is short for triggered modes when a new trigger occurs imme-
diately or the output is delayed to the end of the read cycle on edge and serial trig-
gers.
Beeper Volume
Default: Level 4
Options: Level 4, Level 5, Off, Level 1, Level 2, Level 3
Laser On/Off
Default: Disabled
Options: Disabled, Enabled
Note : A serial or external trigger (see “Triggering Mode” on page 2-16 ) must be
enabled for Laser On/Off to take effect.
When enabled, the laser is ON only during the read cycle. When disabled, the laser
operates continuously.
Note : Laser On/Off does not relate to the Enable Laser Scanning (<H>) or Disable
Laser Scanning (<I>) operational commands on page 4-6 .