Chapter 2
2-20
MS-810 Industrial Scanner User’s Manual
2–Menu Conf
ig
.
Serial Trigger Character
Default:
^]
. Corresponds to <GS> displayed in the menu.
Options: Any single ASCII character, including control characters, except NUL (00H),
an existing host command character,
1
or an on-line protocol character.
Note:
Serial Data (
) or Serial Data & Edge (
) must be enabled
for Serial Trigger Character to take effect. “N/A” is displayed in the menu when all
other triggering modes are enabled.
Allows you to define a single ASCII character as the host serial trigger character that
initiates the read cycle. The serial trigger is considered an on-line host command and
requires the same command format as all host commands (that is, to be entered
within the < > brackets).
External Trigger Polarity
Default:
Positive
Options: Positive,
Negative
Note:
External Level (
), External Edge (
), or Serial Data &
Edge (
) must be enabled for External Trigger Level to take effect. “N/A” is
displayed in the menu when all other triggering modes are enabled.
Allows you to determine whether a positive or negative transition will initiate the read
cycle.
Note:
If using the Microscan object detector (P/N 99-440001-03), use positive trigger
polarity.
Trigger Filter Level
Default:
78
(approximately 10 ms). Corresponds to 9984 µs displayed in the menu.
Options:
2 to 255 (approximately 0.256 ms to 32 ms in 0.128 ms increments). Multi-
ply the number to be entered by 128 for time in microseconds, then divide
by 1000 for time in milliseconds.
Allows you to set a trigger bounce filter duration.
1. For example, assigning an upper case D would nullify the <D> (Enter Menu Configuration)
command. For a list of operational commands used by the scanner, see Chapter 4, “Operational
Commands.”
Summary of Contents for MS-810
