Microscan MS-810, User Manual

Page: 44 / 144

Chapter 2
2-22
MS-810 Industrial Scanner User’s Manual
2–Menu Conf
ig
.
Multilabel Separator
Default: , (comma)
Options: Any available ASCII character, except NUL.
Allows you to choose the separator character to be inserted between each label.
Note : UPC separator character, if used, must be different than the multilabel separator.
Match Code Type
Figure 2-7 Match Code Type
Default: Disabled
Options: Disabled, Enabled, Wild Card, and Sequential
When not disabled, allows you to enter a master label into the scanner's RAM to be com-
pared with subsequently scanned labels. The results of this comparison determine the
scanner’s data and relay outputs, if enabled.
The following conditions apply:
1. A triggered mode (
page 2-16 to page 2-18 ) must be enabled for Match Code Type
to take effect.
2. Not disabling Match Code Type when Number of Labels is set to any number greater
than one will cause Number of Labels to default back to one.
3. If you wish to send a pulse on a Good Read, Match Code Type must be disabled (see
“Output On” on page 2-34 ).
Disabled
Disabled has no effect on operations.
Enabled
Instructs the scanner to compare labels or portions of labels with the master label.