Microscan MS-810, User Manual

Page: 57 / 144

Output Menu
MS-810 Industrial Scanner User’s Manual
2-35
2–Menu C
o
n
fig
.
# Before Output
Default: 1
Options: 1 to 255
Allows you to determine the number of consecutive hits (matches, mismatches, or
noreads as configured by Output On) that must occur before a relay pulse will be sent
from Relay-1 or Relay-2.
For example, if # Before Output is set to 3 and Relay-1 is set to Noread, then relay-1
will not fire until 3 consecutive noreads have occurred.
Note : The hits must be consecutive and each one must match the configured Out-
put On condition. Any interruption in the consecutive sequence will result in a reset
and cause the scanner to start the count over.
Bar Code Output
Default: Good Read
Options: Good Read, Disabled, Match, Mismatch
Note : If Bar Code Output is set to Match or Mismatch, label data will not output
unless Match Code Type ( page 2-22 ) is enabled and a master label is downloaded
into memory ( page 2-21 ).
Allows you to choose the conditions under which label data (or noread messages) will
be sent to the host.
Good Read
The scanner outputs on any good read independent of how Match Code Type is set.
Disabled
The scanner does not output both label data and noread messages to the serial port.
Match (with Match Code Type enabled)
The scanner outputs when the label data information matches the master label. How-
ever, if Match Code Type is disabled it outputs on any good read.
Mismatch (with Match Code Type enabled)
The scanner outputs when the label data information does not match the master
label. However, if Match Code Type is disabled it outputs on any good read.
When to Output (bar code data)
Default: As Soon As Possible
Options: As Soon As Possible, End of Read Cycle
Allows you to choose when bar code data is sent to the host.
As Soon As Possible
Causes bar code data (good reads) to be transmitted immediately upon a good
decode.