Microscan MS-810, User Manual

Page: 51 / 144

Code Type Menu
MS-810 Industrial Scanner User’s Manual
2-29
2–Menu C
o
n
fig
.
UPC
Default: Disabled
Options: Disabled, Enabled
When enabled, the scanner will read UPC version A and UPC version E only.
EAN
Default: Disabled
Options: Disabled, Enabled
Note: UPC must be enabled for EAN to take effect.
When EAN is enabled, the scanner will read UPC version A, UPC version E, EAN 13,
and EAN 8. It will also append a leading zero to UPC version A label information and
transmit 13 digits. If you do not want to transmit 13 digits when reading UPC version
A labels, disable EAN.
Supplementals
Default: Disabled
Options: Disabled, Enabled, Required
Allows the scanner to read supplemental bar code data that has been appended to the
standard UPC or EAN codes.
Enabled
When Supplementals is set to Enabled, the UPC main and supplemental label are con-
sidered to be separate labels. Therefore Number of Labels must be set to 2 and a mul-
tilabel separator will be inserted between the label data and the supplemental label
data.
For example, if Supplementals is enabled, Number of Labels is set to 2, and the Multi-
label Separator Character is defined as a #, the data will be displayed as: LABEL #
SUPPLEMENTAL
If you are using two labels with Supplementals, set Number of Labels to 4.
Note: Under no circumstances will a supplemental label be output without a main label.
Note : Do not set Triggering Mode ( page 2-16 ) to Continuous Read 1 Output. Enabling
Continuous Read 1 Output will cause Number of Labels to default to 1.
Required
When set to Required, the UPC main and supplemental labels are considered to be one label. If
either the main or supplemental label is not read, a single noread message will be output.
For example, if Supplementals is set to Required, Separator is enabled, and an aster-
isk is defined as the Separator Character, then the data will be displayed as: LABEL *
SUPPLEMENTAL.
If set to disabled, the following will be displayed: LABEL SUPPLEMENTAL.