Microplex M204, Installation And Configuration Manual

Page: 99 / 204

USING THE M204’S COMMAND SET: npsh Command Set 91
M204 can resolve the IP name. Please see set sysinfo on page 101 for more
information.
reset
reset
Restore current settings to those stored in EEPROM. Performs a warm boot or
hardware reset, simulating a power-on reset. Use this after a power failure.
save
save
Save the current settings to EEPROM. These parameters include: system
information, destinations, models, logpaths, variables, I/O ports, and port-
maps. Resetting the unit is not required.
save default
Caution
This command overwrites everything and saves factory settings of all parame-
ters to EEPROM, except the factory-programmed Ethernet and Token Ring
addresses. The changes do not affect the current operating parameters until
the M204 is reset.
See also: load on page 89, reset on page 91, and Set Commands on page 91.
Set Commands
Change the current parameters. The three command possibilities are:
set choice parameters
Set some parameters.
set
choice from default
Set default parameters.
set choice from stored
Set stored parameters from EEPROM.
choice and parameters can be any of the following options described next.
Once you have set any parameters, you need to issue a save command to store
these new values to EEPROM. Note