Microplex M204, Installation And Configuration Manual

Page: 133 / 204

USING THE M204’S ADDITIONAL OPTIONS: TCP/IP Options 125
3 Power up the unit in its default state and configure as desired.
4 After configuring the Print Server, be sure to return the jumper strap to EEPROM
Enable and repower the unit.
Through npsh
To restore the network default settings through the M204’s command set:
1 Use a Telnet session or connect a terminal to a COM port of the Print Server.
2 Once logged in as a root user, restore factory defaults by entering:
store tcpip from default
3 Reboot the M204 and reconfigure its settings according to one of the methods dis-
cussed in M204 Configuration on page 23.
Figure 4: M204 Jumper Settings
Getting Ready for Complex Networks
The default settings on the Print Server allow printing in a simple network without
routers. You need to add routing information to communicate or print from hosts on
other networks.
To do this, you can establish either of the following: