Microplex M204, Installation And Configuration Manual

Page: 74 / 204

66 CONFIGURING THE M204 FOR APPLETALK: Additional Configuration Options
Disabling the AppleTalk Module
If you have several Microplex Print Servers in your network and only some of them
are servicing AppleTalk networks, it is a good idea to turn off the entire AppleTalk
module from the particular Print Server. This will not only save on Print Server
resources but will ensure that only appropriate Print Servers show up in the Chooser.
To disable the AppleTalk module, start an npsh session with the unit and follow the
steps below:
1 Remove AppleTalk from the available protocols.
set sysinfo module -appletalk
In the same way, you can also turn off the Novell protocol if the Print Server is not
servicing any Novell networks. The TCP/IP module cannot be turned off.
2 Save the changes to EEPROM.
save
If you want to continue with any of the following procedures, please find them as indi-
cated in other sections of this manual:
• Add to or change configuration of your M204. Please see USING THE M204’S
COMMAND SET on page 81.
• Utilize more advanced features of the Print Server. Please see USING THE
M204’S ADDITIONAL OPTIONS on page 119.
Note