Microplex M204, Installation And Configuration Manual

Page: 101 / 204

USING THE M204’S COMMAND SET: npsh Command Set 93
[-]igndcd Disable this feature if you are using a modem connected to
the COM port to establish terminal sessions.
[-]onlcr Enable [disable] carriage return insertion.
[-]opost Allow output processing such as onlcr, xtab, and descram-
bling. With “-”, do not allow any of this processing.
[-]slip Sets the specified serial port as a dedicated SLIP connection.
This command will fail if the serial port is already configured
as a print destination. Users must reconfigure the M204’s
destinations so that none of the destinations are mapped to
the serial port that you want to use as a dedicated SLIP con-
nection.
flush Flush the data in the serial I/O port input and output buffers.
unlock Release the access lock on the serial I/O port.
Caution
When an I/O port is active, unlock can cause output from two jobs to mix.
set com1|com2 timeout < INT>
Terminate the print job sent to the I/O port if it is not printed after the timeout
period (INT is time in minutes in the range of 0 to 255). If the timeout is set to
zero (0), the timeout feature is disabled.
Printer errors will cause the M204 to postpone printing until the printer is
fixed regardless of this timeout feature being set or not. Therefore, no data
will be lost.
set com1|com2 xtab <
INT>|none
Sets the tabstop width. INT is an integer within the range 1 to 1
Note
Note