Microplex M204, Installation And Configuration Manual

Page: 105 / 204

USING THE M204’S COMMAND SET: npsh Command Set 97
set model
set model
modelname banner [ps|text|auto] [after]
Indicate if destinations using modelname are to send a banner page. If a ban-
ner page is to be sent, indicate the type according to the printer attached.
Specifying after will print a trailing banner at the end of the job.
The banner type and the printer type must match.
set model modelname stty [[-]onlcr] [[-]descramble] [xtab
<1-16>|none]
Control extra job processing done by the model specified by modelname:
onlcr Indicate whether or not isolated linefeed characters should be
converted to CR LF (carriage return - linefeed) pairs. Turn
this on when lines stair-step down the page, starting a new
line without returning to the original line beginning.
onlcr may slow throughput performance on the M204.
descramble Set the model to automatically descramble any print jobs
passing through. These jobs must pass through the scram-
bling filter, npscramble, on a TCP/IP host first. If they do
not, the jobs will pass through as is.
To set this feature on, you must configure the descramble key
first. Please see set sysinfo on page 101 for more on this
requirement and for further details, please see Host Software
on page 19 and Scrambling/Descrambling on page 127.
xtab Sets the tabstop width within the range of 1 to 16.
set model modelname header headerstring
Set the header string for a named model. The header precedes every job that
goes to a destination using the named model. headerstring is a string with a
maximum of nine elements; each element may include a letter, code (e.g.
0x04), or variable (e.g. $FF).
Note
Note
Note