COLD WEATHER OR EXTENDED STORAGE
eng
123
1. Ensure that all cooling system hoses are connected properly
and hose clamps are tight, all removed drain plugs have
been installed and are tight.
!
CAUTION
Disconnecting or connecting the battery cables in the
incorrect order can cause injury from electrical shock or can
damage the electrical system. Always disconnect the
negative (‑) battery cable first and connect it last.
2. Install fully‑charged battery. Clean battery cable clamps and
terminals and reconnect cables. Tighten each cable clamp
securely when connecting.
3. Coat battery terminal connections with a anti‑corrosion
agent.
4. Perform all checks in
Operation Chart
in the
Before
Starting
column.
5. Refer to
Flushing Cooling System
before starting engine.
6. Supply water to engine cooling system.
STARTING WITHOUT PRIMING THE FUEL SYSTEM
IMPORTANT: The throttle must not be advanced until the engine
idles and runs smoothly and the water temperature reaches a
minimum of 54 °C (130 °F). Advancing the throttle prematurely
while the PCM is in its rich running mode will result in poor
engine starting and performance.
1. Connect the main permanent fuel line to the engine.
2. Do not advance the throttle until the engine idles and runs
smoothly and the water temperature reaches a minimum of
54 °C (130 °F).
3. Crank the engine over for 10 seconds at a time and stop.
4. Repeat cranking procedure until the engine starts and runs
smoothly. Observe instrumentation to ensure all systems
are functioning.
5. Inspect engine for fuel, oil, fluid, water and exhaust leaks.
6. Check steering system, shift and throttle control for proper
operation.
Summary of Contents for HP525 EFI Bravo Sterndrive Series
Page 4: ...iv eng ...
Page 9: ...eng ix Maintenance Log Maintenance Log 137 ...
Page 10: ...x eng ...
Page 54: ...OPERATION 44 eng 1 7 3 5 4 6 2 1 4 2 3 6 4 2 8 6 7820 3 7 ...
