134
BA023001-en
b.
Use the Up (˄) and Down (˅) buttons to scroll between functions. The selected
symbol can be confirmed by pressing the (ok) key. The function icons are displayed
highlighted.
c.
If a remote control is logged into the test bench, the <Burger menu> button will be
highlighted after a restart and selection of "New Vehicle".
•
Load simulation
a.
Pull-down device
The (+) button is used to retract the cylinders, thereby increasing the pull on the
vehicle frame.
The (
–
) button is used to extend the cylinders, thereby reducing the pull on the
vehicle frame.
b.
Roller set lift
The (+) button is used to extend the cylinders, which in the case of tandem axles
increases the weight of the axle under test.
The (
–
) button is used to retract the cylinders, which in the case of tandem axles
reduces the weight of the axle under test.
•
Emergency stop
If the emergency stop switch is pressed, the motors switch off immediately. If the
emergency stop is active, the head of the emergency stop switch lights up red.
a.
The emergency stop is active, if
–
the remote control is switched on and connected to the receiver (pairing).
b.
The emergency stop is inactive, if
–
the remote control is not logged on to the test bench.
–
the remote control is in the charging box.
–
the remote control is out of range of the radio link.
–
the battery of the remote control is discharged.
•
Preselection in the burger menu
Before entering the brake tester, preselections can be made (test direction, single
wheel, four-wheel, pre-trigger etc.). The exception is the main direction of rotation (set
as default).
The LEDs for the direction of rotation display on the remote control show the same
behaviour as the direction of travel arrows in the status bar (synchronous)!
a.
Main direction of rotation (= default)
Sequence of motor start as standard: first left motor, then right motor. By default,
the selection in the burger menu is set to "Main direction of rotation".
If the selection is elsewhere, use the Up (˄), Down (˅) navigation
buttons to select.
Confirm with (ok).
(Slide switch in burger menu goes ON.)
Summary of Contents for CONNECT Series
