MAHA CONNECT Series, Original Operating Instructions

Page: 56 / 138

56
BA023001-en
each for a traction force. The notches for the MBT 2000 are used for the adjust-
ment of all roller sets with Ø 200.
6 Place the 30 kg adjustment weight on the 3 kN mark. The adjustment arm must be
in balance with the applied weights. The spirit level is used for verification.
Depending on the adjustment method, errors are taken into account for inexact
alignment.
7 Preload the adjustment device 3x with maximum value.
8 Perform adjustment: press “Adjust” button.
9 Remove the weight and check the zero point. The zero point must not be re-
adjusted again. It must therefore be ensured that no force acts on the brake
tester’s range spring when no weight is applied. If there are excessive deviations,
the adjustment must be performed again.
10 Repeat the process for the right-hand side.
5.1.3 Adjusting brake forces with MJV II
See quick reference guide BA020001_003, available for download on the MAHA
homepage www.maha.de.