MAHA CONNECT Series, Original Operating Instructions

Page: 115 / 138

115
BA023001-en
NOTICE
These dowels are suitable for concrete, solid brick, sand-lime brick. For other materi-
als, suitable fastening systems must be used on site!
1 Mark the upper drill holes on the selected wall according to the sketch and using a
spirit level. Drill to a depth of at least 70 mm using a suitable 10 mm masonry drill
bit.
2 Insert the upper dowels and screws into the holes and screw them in at a distance
of 10 mm from the wall.
3 Hang the wall mount on the pre-installed screws via the keyholes, align with a
spirit level if necessary and tighten the screws.
4 Drill the lower drill holes to a depth of at least 70 mm using a suitable 10 mm
masonry drill bit. Insert dowels with screws and tighten.
NOTICE
Check wall mount for tight fit after installation! Observe local and country-specific
Cable fastening Cable tie
Locking Swivel arm
Adjustment VESA mount