MAHA CONNECT Series, Original Operating Instructions

Page: 45 / 138

45
BA023001-en
6 If a drill with sufficient length is not available, remove the sensing roller spiral
spring (marked red) if necessary. Dismantling of the spiral spring must be carried
out identically on the left and right.
7 Center the test bench all around in the foundation, then drill a minimum depth of
90 mm at the fixing points (marked red) using a suitable 10 mm masonry drill bit.
The fixing holes must be made identically on the left and right.
8 Drive in the bolt anchor, check the test bench centering in the foundation again.
Tighten bolt anchor with ratchet and extension WAF 17.