LOAD KING 80-160, Operator'S Manual

Page: 263 / 369

263
Turntable and Swing Pinion
1. Swing Bearing Grease Port
2. Swing Gear Grease Port
Lubricate every 100 operating hours as follows:
Inject grease as recommended below through both grease zerks item (1) and (2) located in the operator’s
cab on the right console forward of the cup holder. Machine is to be slowly rotated at least two complete
revolutions while injecting grease. When complete rotation is impractical, inject grease through each
fitting and rotate machine back and forth as far as possible as each fitting is greased.
Under extremely dirty or dusty conditions, sufficient grease should be added to flush out contaminated
grease. Under less severe conditions, add grease until it appears at the bottom seal.
While swinging the machine, apply gear grease to the external ring gear with sufficient frequency to
insure that the teeth remain coated.