LOAD KING 80-160, Operator'S Manual

Page: 131 / 369

131
Inspection
Pre-Start Inspection
The following items should be checked each day before start-up and the start of operations.
Also see “Daily Check.” on page 138.
ENGINE OIL
The level should be at the full mark.
COOLANT
The level should be near the bottom of fill neck in coolant tank when cold.
DIESEL EXHAUST FLUID
Check diesel exhaust fluid (DEF) or Urea tank level is full. An illuminated Warning on dash or
Check Engine light will indicate a low level. (Tier 4 engine models only)
LEAKAGE
Make a ground check below the machine for signs of leaks. See Hydraulic Hose topic in Maintenance
section.
FUEL
Fuel for the engine and for upper unit heater should be adequate for sustained operations.
LUBRICATION
Perform the daily lubrication as required in the Lubrication Recommendations. Lubricate cylinder
mounting bushings, and pins.
LINES AND BLOCKS
Inspect the hoist lines, hoist block and ball hook, and the crane attachment in general for readiness.
SAFETY EQUIPMENT
Check the safety equipment, including all lights, brakes, and hazard warning devices.
TIRES
The tires should be checked for proper pressure before traveling the machine. The tires should only be
checked when cold. Refer to the Tire Pressure Chart in the operator’s cab.
WHEEL NUTS
Torque all lug nuts to carrier chassis supplier recommendations. Check tightness daily during the first
50 miles of service on new units and any time the wheels have been removed. Ensure proper alignment
of tire and rim assemblies.