LOAD KING 80-160, Operator'S Manual

Page: 191 / 369

191
1.
Outrigger Beam Lock Pin
- shown in (locked) position, lift bolt, rotate pin clockwise until bolt
drops into slot lowest position which will prevent beam from extending. Never drive crane without
locking all (4) four pins.
2.
Outrigger Pad Storage
- Insert lockpin as shown above (1) one place on each pad and repeat this
procedure on (4) four outrigger pads.
- Stow the boom in the boom rack.
- Watch for overhead obstructions such as trees, power lines, or bridges.
- If the terrain is rough or uneven it may be necessary to travel at a reduced speed to prevent
instability or damage to the crane.
- Operating on steep grades requires caution because the oil in the engine or transmission will move
to one side of the engine or transmission. As a result, the engine or transmission may not be fully
lubricated which could damage the engine or transmission.
- The operator must be very careful on steep side slopes to avoid tipping the crane.
NOTE:
This machine can travel on 15° side slopes which have a firm level prepared surface. Due to
variations in the ground surface, tire pressure, bumps, potholes, etc., we recommend that travel on
side slopes be limited to 5° and that the boom be horizontal or below.
Crane Setup’s and Moving of Unit Restrictions - strict adherance to the below chart
must be followed or damage can result to front axles due to overloading or structural
damage to crane due to dynamics of jib in erected state.