Lenze EVS 9300 series, System Manual

Page: 501 / 504

Index
abc
14-9
L
EDSVS9332S EN 3.0
phase addition block (PHADD), 9-178
Phase adjustment, 8-15
Phase comparator (PHCMP), 9-179
Phase controller, 8-24
- Influence of phase controller, 9-142
- phase controller limit, 8-24
Phase controller limit, 8-24
Phase controller overflow P13, 9-243
Phase conversion (CONVPHA), 9-85
Phase conversion (CONVPHPH), 9-86
Phase integrator (PHINT), 9-183
- constant input value, 9-185 , 9-186
- Input value with sign reversal, 9-187
- Scaling of PHINTx-OUT, 9-188
Phase offset, 8-15 , 8-25
Phase signal adaptation (PHDIV), 9-182
Phase synchronism, 8-24
Phase trimming, 8-14 , 8-25
Phase-synchronous operation, 8-11 , 8-24
Positioning control with driftfree standstill, 8-11
Power connections, 4-23
- Max. permissible cross-sections, for mains connection, 4-26
Power stage identification H07, 9-227
Process controller (PCTRL1)
- Control characteristic, 9-176
- Dancer position, tension, pressure controller, 9-175
- Ramp function generator, 9-177
Process controller adaptation, 9-264
Process input words, 9-284
Process output words, 9-283
Processing times, system bus (CAN), 4-54
Profile generator, 8-28 , 8-31 , 9-192
- gearbox ratio, 8-31
- home position offset, 8-31
- homing speed, 8-31
- homing Ti time, 8-31
Protection, controller, 4-21
Protection against contact, 4-20
Protection against inverse polarity, 4-40
Protection of devices, 2-3
- Current derating, 6-5
Protection of persons, 2-3 , 4-19
- Insulation, 4-20
- Residual-current circuit breaker, 4-19
Protective insulation of control circuits, 3-2
Q
QSP (quick stop), 8-7 , 9-143
QSP at the master, 8-15
QSP at the slave, 8-18 , 8-21
QSP at the slave 0, 8-15
QSP deceleration time, 9-259
Quick stop (QSP), 8-7 , 9-93
Quick stop QSP, 9-143
R
Ramp function generator, 9-177
Ramp generator(RFG), 9-197
Rated data
- 200% overcurrent, 3-5
- Cable cross-sections, 3-7
- Fuses, 3-7
- Mains filters, 3-8
- Types 9321 to 9325, 3-4
- Types 9326 to 9332, 3-6
Rated motor power, 9-258
Rated motor voltage, 9-258
Reactions, 9-219
- Setting, 9-220
Referencing, 8-28
Reset, fault indication, 10-10
Residual hazards, 2-3
Residual-current circuit breaker, 4-19
Resolver connection, 4-48
Resolver monitoring Sd2, 9-246
Resolver poling, 5-5
Restart protection, 9-154
Rotor position adjustment, 5-5