Lenze EVS 9300 series, System Manual

Page: 264 / 504

Function library
Function blocks
9.2.40 Internal motor control (MCTRL)
9-138
L
EDSVS9332S-D11 EN 3.0
Function
z Current controller
z Torque limitation
z Additional torque setpoint
z Speed controller
z Torque control with speed limitation
z Speed setpoint limitation
z Phase controller
z
Quick stop QSP
z Field weakening
z Switching frequency changeover
9.2.40.1 Current controller
Adapt current controller via C0075 (proportional gain) and C0076 (reset time) to the machine
connected.
Tip!
Set a suitable motor from the selection table ”Motors” under C0086. (

9-315)
With this the parameters of the current controller are automatically set correctly.
9.2.40.2 Additional torque setpoint
The input MCTRL-M-ADD serves as torque setpoint or additional torque setpoint, depending on the
control of the input MCTRL-N/M-SWT. The additional torque setpoint can be used e.g. for friction
compensation or speed injection (dv/dt).
z When MCTRL-N/M-SWT = LOW the speed control is active.
– MCTRL-M-ADD is added to the output of the n-controller.
– The limits defined by the torque limitations MCTRL-LO-M-LIM and MCTRL-HI-M-LIM
cannot be exceeded.
z When MCTRL-N/M-SWT = HIGH, the torque control is active.
– MCTRL-M-ADD acts as torque setpoint
– The n-controllers have a monitoring function.
z The torque setpoint is defined in [% ] of the max. possible torque (see code C0057).
– Negative values mean a torque with CCW rotation of the motor.
– Positive values mean a torque with CW rotation of the motor.