Lenze EVS 9300 series, System Manual

Page: 235 / 504

Function library
Function blocks
9.2.27 Digital frequency ramp function generator (DFRFG)
9-109
L
EDSVS9332S-D11 EN 3.0
9.2.27.7 Correction of the touch probe initiator (terminal X5/ E5)
Delay times during the activation of the initiator cause a speed-dependent phase offset (e.g. during
positioning, synchronising).
z Set correction value for the phase offset under C0429.
z Formula for correction value:
Correction value C0429 = 16384 × correction value
z You can take the correction value from the data sheet of the initiator or contact the
manufacturer.
9.2.27.8 Offset setting
The offset can be set with the code C0756 (see chapter 9.4; code list). The offset refers to the digital
frequency input and is scaled to one revolution (
≙
65536 increments).
The touch probe (TP)initiates the start of the ramp function generator. The leading of the master drive
from the moment of starting or the resulting path/phase difference is taken up during the acceleration
phase.
z Setting: positive offset values
– Causes a time shift of the TP
– This means that less time is necessary - compared to the setting with e.g. offset = 0 - to
obtain synchronism with the master drive.
Tip!
With high offsets and low input speeds the drive may reverse. To avoid this, a direction of rotation
can be selected for the output via C0766.