Lenze EVS 9300 series, System Manual

Page: 122 / 504

Parameter setting
Parameter setting using the keypad
7-8
l
EDSVS9332S-D11 EN 3.0
Copying parameter set from the keypad into the basic device
Step Key sequence Action
1. Connect the keypad to the basic device 2
2. Inhibit controller: Terminal X5/28 = LOW
The drive coasts
3. Pull the plugs X5 and X6 All control terminals have the defined state ”LOW”.
4. Select C0002 in the menu ”Load/Store”     Select code C0002 ”PAR LOAD” in the menu ”Load/Store” using the
arrow keys.
5. Change to the parameter level  Display ”0” and ”Load Default”
6. Select the correct copy function The settings stored in the basic device are overwritten.
• Copy all available parameter sets into the basic device and save them permanently.

Set ”20” ”ext -> EEPROM”
• Copy single parameter sets to the main memory.
 Copy parameter set 1:
Set
Ö ”11” ”Load ext PS1”
Copy parameter set 2:
Set
Ö
”12” ”Load ext PS2”
Copy parameter set 3:
Set
Ö
”13” ”Load ext PS3”
Copy parameter set 4:
Set
Ö ”14” ”Load ext PS4”
7. Start copying
 
”RDY” goes OFF. ”BUSY” is displayed.
When ”BUSY” goes off, the selected parameter sets are copied to the
basic device.
8. Change to the code level
A)

Display of the operating level
B)

Display C0002 and ”PAR LOAD”
9. If necessary, store separately copied parameter
sets
    Select code C0003 ”PAR SAVE” in the menu ”Load/Store” using the
arrow keys and permanently store the contents of the main memory.
10. Plug in plugs X5 and X6
11. Enable controller
Terminal X5/28 = HIGH
The drive is running with the new settings.