Leica 14 9AUTO00C1, Instructions For Use Manual

Page: 69 / 120

69 HistoCore AUTOCUT
Optional Accessories
6
6.1.2 Directional fixture for specimen clamps
Fig. 69
1
2
3
4
5
6
7
8
• Loosen the eccentric bolt (
→
"Fig. 69- 1 ") by
turning it counterclockwise.
• Completely unscrew the thrust piece ( → "Fig.
69- 2 ") with a flat-tip screwdriver and pull it out
with spring (
→
"Fig. 69- 3 ") and pin (
→
"Fig. 69- 4 ") .
• Completely unscrew the setscrews ( → "Fig. 69- 5 ")
and ( → "Fig. 69- 6 ") .
• Install the directional fixture for specimen clamps
by tightening the screws in the bores ( → "Fig.
69- 8 ") (2 screws are accessible through the bores)
and screw them in using an Allen key No. 3. Insert
the screws (
→
"Fig. 69- 7 ") in the bores as shown
and screw them in using an Allen key No. 3.
• Insert the spring ( → "Fig. 69- 3 ") and pin ( → "Fig.
69- 4 ") with the flatter side into the thrust piece
(
→
"Fig. 69- 2 ") . Completely screw in the thrust
piece with a flat-tip screwdriver.
• Completely screw in the setscrews ( → "Fig. 69- 5 ")
(
→
"Fig. 69- 6 ") .
6.1.3 Fine-directional fixture for specimen clamps
Fig. 70
1
3
4
2
• Before the fine-directional fixture for specimen
clamps can be mounted, loosen 4 screws
( → "Fig. 70- 2 ") (Allen key No. 3) and carefully
remove the fixture for specimen clamps from
the baseplate (
→
"Fig. 70- 1 ") .
• Using the 4 supplied screws ( → "Fig. 70- 3 ") and
the Allen key No. 3, fasten the baseplate to the
object head ( → "Fig. 70- 4 ") .
• Now, screw the fine-directional fixture for
specimen clamps with the 4 screws ( → "Fig.
70- 2 ") and the Allen key No. 3 onto the object
head.