Leica 14 9AUTO00C1, Instructions For Use Manual

Page: 79 / 120

79 HistoCore AUTOCUT
Optional Accessories
6
Fig. 83
1
2
Lateral displacement
The lateral movement feature of the two-in-one
blade holder E enables the use of the entire length
of the blade by moving the clamping top laterally.
Three predefined stop positions (left, center,
right) that correspond to the width of a standard
cassette may be used if desired.
• To release the clamping, rotate the lever
( → "Fig. 83- 1 ") on the left side of the two-in-one
blade holder E counterclockwise.
• Move the clamping-top (
→
"Fig. 83- 2 ") laterally.
• To clamp, rotate the lever ( → "Fig. 83- 1 ")
clockwise.
6.3.4 Knife holder E with a water trough for low-profile blades
Fig. 84
3
1
2
The knife holder E with a water trough ( → "Fig.
84") is only for low-profile blades.
The safety guard on knife holder E consists of a
red foldaway handle ( → "Fig. 84- 1 ") . To cover the
cutting edge, fold the safety guard handle ( → "Fig.
84- 1 ") clockwise as illustrated in the figure.
Tips
The clamping levers on the knife holder are not interchangeable. The two clamping levers ( ( → "Fig.
84- 2 ") and ( → "Fig. 84- 3 ") ) must remain in the position shown at all times, as otherwise isolated
malfunctions of the knife holder can occur.
Clamping lever for the blade
( → "Fig. 84- 2 ") is at the right, clamping lever for the lateral displacement
(
→
"Fig. 84- 3 ") is at the left.