38
Version 1.1, Revision B
Setting up the instrument
4
4.5.5 Connecting the control panel
Fig. 19
1
2
3
4
The connecting cable
of the control panel is fixed to the microtome. It may not be
disconnected.
1. Insert the plug
of the connecting cable into the connecting jack
on the rear of the control panel.
2. To fasten the plug, tighten the two screws
4.6
Switching on the instrument
Warning
Condensation inside the instrument due to exposure to extreme differences in temperature and high
air humidity.
Damage of the instrument.
• Always make sure that for both storage and operation appropriate climate conditions are met. See
.
• After transporting the instrument, wait at least two hours to allow the instrument to adopt the
ambient temperature before turning it on.
Warning
Misinterpretation of the yellow LED in the
M-STOP
field.
Serious injury of persons and/or property damage.
• Operate the instrument once after you have completely understood the meaning of the 3 possible
LED indications. Extinguished light: the device is ready to use (no brake engaged); Blinking light:
the electronic brake is engaged but mechanical locking system is deactivated; Permanent light:
the mechanical locking system is activated.
• The handwheel is securely locked only when the handwheel locking mechanism is in the 12
o'clock position.
Tip
When turning the instrument on with the power switch, do not press any of the buttons of the control
panel or the foot switch (optional accessory), except when you set specific functions. For more
information, please refer to
.
