17. External Interface
17-3
17.2 TELNET
You can use the Ethernet connector on the rear panel and a PC to perform operations
remotely. The operations that you can perform are approximately the same as those that you
can perform using the front panel.
17.2.1 Procedure
1 Set the IP address, subnet mask, and gateway on the LV 5330.
These items can be configured in the system settings.
If necessary, ask you network administrator what values you should use.
Reference: Section 5.4.2, “Configuring Ethernet Settings”
2 Restart the LV 5330.
The IP address, subnet mask, and gateway values that you set become valid.
3 Connect a cable to the LV 5330 ETHER connector.
Use a cross cable to connect the LV 5330 to a PC directly. Use a straight cable to
connect the LV 5330 to a PC through a hub.
4 Start
TELNET.
After you start TELNET, the following display appears.
For information on how to start TELNET, see your PC user’s manual.
login:
5 Enter the login name, and press Enter.
The login name is LV5330. Be sure to use capital letters.
You cannot change the login name.
login: LV5330
6 Enter the password, and press Enter.
The password is LV5330. Be sure to use capital letters.
You cannot change the password.
Password: ******
7 Enter
commands.
After you enter the password, the following command prompt appears.
Enter commands while referring to section 17.2.2, “How to Enter Commands,” and
section 17.2.3, “TELNET Commands.”
LV5330>
