14. Status Display
14-1
14. Status
Display
14.1
Status Display Explanation
To show the status display, press STATUS.
Figure 14-1 Status display
Figure 14-1 Status display explanation
Item Display
Explanation
SIGNAL
Indicates whether or not an SDI signal is being applied to one of the SDI input
connectors.
“NO SIGNAL” may appear even when an SDI signal is applied to one of the
connectors if the signal amplitude is small or if there is a lot of jitter.
If “NO SIGNAL” appears, the rest of the information that follows will be blank.
DETECT
An SDI signal is being applied.
NO SIGNAL
An SDI signal is not being applied.
FORMAT
Indicates the video signal format detection status. The meanings of the
indications vary as described below depending on whether the input format in the
system settings has been set to AUTO or MANUAL.
If “UNKNOWN” appears, the rest of the information that follows will be blank.
Reference: Section 5.1, “Setting the Input Format”
NORMAL
When the input format is set to AUTO, this indication means that a signal that the
LV 5330 supports is being applied.
When the input format is set to MANUAL, this indication means that a signal is
being applied whose format is the same as that of the manually specified format.
UNKNOWN
When the input format is set to AUTO, this indication means that a signal that the
LV 5330 does not support is being applied.
When the input format is set to MANUAL, this indication means that a signal is
being applied whose format is other than that of the manually specified format.
TRS
Indicates the TRS error detection results.
A TRS error occurs when the EAV and SAV of the SDI input signal are not in the
right places.
NORMAL
No errors have been detected.
ERROR
An error has been detected.
Blank
TRS ERROR has been set to OFF.
Reference: Section 14.6.3, “Configuring Error Detection Settings”
