26
3
System Description
3.2.2
Digital Outputs
List of digital outputs, version V1.0.3:
3.2.3
Assignment of Input/Output Functions
(logic signals to the input/output terminals)
The input and output functions (logic signals) of the physical terminals in the CMS are as-
signed using the I/O matrix in the CMS remote software. Among these, there are signals
whose use is mandatory and those whose use is optional. To help with this assignment, the
CMS remote software provides a link matrix and a link table.
See chapter
7.3.3.4, section
Pressure before valves > min.
Signal to switch off if pressure < min.
If the pressure drops below the minimum value, a
fault shut-down is initiated.
4 Signals for the chains 1 ... 4 are possible.
Safety chain input
User-configurable input for a safety chain function,
see chapter
Curve set selection
Signal for curve set pre-selection (max. 16 possible),
see chapter
Firing rate+/firing rate
−
These signals increase or reduce the burner firing
rate if the regular firing rate input is configured to TPS.
Soft PLC input signal
User-programmable input via PLC
* The signals "Main flame present" are logically connected in series (AND operation).
Input
Description
Output
Description
Pilot valve 1+2
Activates the pilot valves
Fuel train 1–4
valves 1+2
Activates valve 1 and valve 2 in fuel
trains 1–4
Spark igniter per fuel train
1–4
Activates the spark igniter for fuel trains 1–4
Purge valve 1–4
Activates purge valves 1–4
Fault status signal
Indicates that CMS is in fault state.
Fan
Activates the fan
Fuel pump
Activates the fuel pump
Atomiser steam 1–4
Activates atomiser steam valves 1–4
Pilot fan 1–4
Activates the motor for pilot fans 1–4
Activation of the mechanic
ratio control
Provides floating contacts for controlling a servo
motor in combination with a mechanic ratio control.
Summary of Contents for AEC-TPS
