Tenera Installation Instructions 56
Mount the Angle Shading
■
Hold the shading up to the brackets with the front
side of the shading facing forward.
■
Starting at the top, attach each fabric support clip,
one at a time, onto a bracket until the shading
is secure. If necessary, slide each clip along the
polystrip to align it with the bracket. Do not place or
slide the clips over the end of a fabric vane.
Adjust the Angle Shading
Install the Opposite End Stop Strips (Optional)
Stop strips have been pre-installed at one end of each polystrip to prevent the shading from
sliding completely through the fabric support clips. After the shading is centered in place, you
may want to install a stop strip to the other end to tension the shading.
■
Gently pull on the end of the
front polystrip to lightly tension
the strip and smooth the face
fabric.
■
Peel the backing off of the
short adhesive-backed
stop strip.
■
Adhere the stop strip to the
tensioned polystrip against
the edge of the bracket to
maintain tension.
■
Trim the excess stop strip flush with the edge of the shading.
Slide the fabric
support clip on
to the bracket.
Fabric Support
Clip
Bracket
Adhere the stop
strip against the
edge of the bracket.
Trim Excess
Stop Strip.
