Tenera Installation Instructions 13
If You Have an Optional External Eye (Infrared Only)...
The plastic of the external eye can be painted. Do
not
paint the infrared eye.
CAUTION:
Handle the external eye carefully to avoid damaging the infrared eye. Do
not
touch or
push the infrared eye.
■
Choose a location where the infrared signal from the remote is not obstructed. Check that the
wire is not caught or pinched in the brackets or headrail.
IMPORTANT:
For infrared operation, do
not
mount the external eye in direct sunlight or bright,
focused light from halogen or fluorescent light fixtures, track lighting, spotlights, or neon lights.
■
Break off the back cover from the snap-on front cover.
■
Place the back cover at the desired location.
■
Mark the screw hole.
■
Drill the screw hole using a
3
/
32
" drill bit.
■
Attach the back cover using the screw provided.
■
Place the infrared eye into the back cover with the eye
facing out.
■
Snap on the front cover with the hole placed over the infrared eye.
If You Have an Optional Dust Cover (For Outside Mount Shadings)...
The dust cover is used to protect the top of the headrail from exposure to
dust on outside mounted shadings.
■
Cut the dust cover to desired width.
■
Remove the paper backing on
one side
of the hook and loop fastener dots.
■
Apply the dots to the installation brackets on each end of the shading
.
■
Remove the remaining paper backing from the dots.
■
Center the dust cover over the top of the shading, above the previously placed dots.
■
Press the dust cover down onto the dots.
Back
Cover
Snap-On
Front Cover
Snap-On
Front Cover
Back
Cover
Infrared
Eye
6-Pin Connector
External Eye With Snap-On Cover
Remove
Paper
Backing
Overhead View — No Dust Cover
Dots
Dust Cover Installed
Overhead View — No Dust Cover
Dots
Dust Cover Installed
