Tenera Installation Instructions 21
Resetting the Shading
If you need to reset the limits:
Basic Reset
■
Press and hold the manual control button for 6+ seconds. The shading moves slightly up
and down
once
to indicate that it has been reset. Release the button.
■
Press and release the manual control button to close the shading completely. This sets the
lower motor limit.
■
Press and release the manual control button again to open the shading completely. This sets
the upper motor limit.
Factory Reset (Professional Installation Only)
To clear all stops, erase all radio frequency (RF) programming, and reset the shading to
factory default:
■
Press and hold the manual control button for 12+ seconds. The shading moves slightly up
and down
twice
to indicate that it has been reset. Release the button.
■
Press and release the manual control button to close the shading completely. This sets the
lower motor limit.
■
Press and release the manual control button again to open the shading completely. This sets
the upper motor limit.
NOTE:
Both upper and lower motor limits have been reset. However, any intermediate stop
position is still cleared; and all RF programming has been erased and will need to be set
up again.
