Tenera Installation Instructions 66
■
Use a level to check that the mounting surface is level. Shim the brackets, if necessary. (Use
the top tab that was removed from the brackets.)
■
Use a
3
/
32
" drill bit to drill holes for the mounting screws.
IMPORTANT:
Use drywall anchors when mounting into drywall.
■
Attach the installation brackets using the screws provided.
IMPORTANT:
Do not overtighten the screws. Check to ensure the lever can be moved
easily side to side. If the lever is not moving easily, loosen the screws in
1
/
8
of a turn
increments until it can be moved easily.
IMPORTANT:
The front edges of the installation brackets must be level and aligned to
each other.
Proceed to “Attach the Back Cover (Optional for Inside or End Mounts)”
or proceed to “Install the Shading”
Mount the Installation Brackets — Outside Mount
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark each end of the headrail.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail
end points over the window opening.
■
Mark 2" to 3" from each end of the headrail.
➤
If more than two installation brackets came with your order, space additional bracket(s)
evenly between the two end brackets and mark their location. Mount into wood
whenever possible.
➤
Use pliers to break off the top tab of each installation bracket.
Save this tab once removed. It may be used as a shim, as described
later in these instructions. Remove the bottom tab on each installation
bracket only if it interferes with the bracket installation.
■
Two-On-One Headrail Shadings.
Two additional installation brackets
should be placed on each side of the panel split.
Headrail End Marks
Window Opening
Space Evenly
Space Evenly
2" – 3"
2" – 3"
Top
Tab
Lever
Bottom
Tab
