Tenera Installation Instructions 26
Removing the Shading
■
Fully raise the shading.
■
Disconnect the power source and the external eye from
the power cable at the back of the shading.
■
Move each lever of the installation brackets to the left to
release the shading.
CAUTION:
A flat blade screwdriver can be used to move
the lever. Be very careful not to tear or damage the fabric.
➤
If the lever is inaccessible
or inoperable, lower the
shading until you can
see the underside of
the bracket. Carefully
reach a small flat blade
screwdriver behind the
shading to the tab on the
bottom of the bracket
between the screw holes.
➤
Push the tab away from
the shading and pull the
headrail to release it from
the bracket.
■
Carefully pull the headrail to completely remove the shading from the brackets.
Cleaning Procedures
Sheer shadings are made of 100% polyester, which means they are inherently durable and
resilient. However, care must be taken to avoid wrinkling the fabric, particularly where the vanes
meet the facings.
Dusting
Regular light dusting with a feather duster is all the cleaning that is needed in most
circumstances.
Vacuuming
Use a low suction, hand-held vacuum for more thorough dust removal.
Forced Air
Blow away dirt and debris between the vanes using clean compressed air.
Move the lever to the left
to release the shading.
Top View
Tab
Installation Bracket
End Cap
Underside of
Bracket
