Tenera Installation Instructions 14
STEP 3 — Connect the Power Source
If You Have a Battery Wand or Satellite Battery Pack...
Install the Batteries into the Battery Wand
■
Squeeze the cap latch to release the cap.
■
Remove the cap from the battery wand.
■
Install the batteries according to the
instructions on the battery wand label.
➤
AA alkaline batteries are recommended
for use with Battery-Powered shadings. These will provide approximately one year
of operation, depending on usage. Lithium and rechargeable batteries are not
recommended.
■
Replace the cap.
➤
Align the tab with the end of the wand.
➤
Press the cap on until it latches.
IMPORTANT:
If you have a satellite battery pack, proceed to “Mount the Satellite Battery
Mount the Battery Wand into the Battery Wand Clips
■
Place the battery wand with its socket toward the motor
end of the shading.
■
Push the battery wand straight up into the battery wand
clips until it snaps into place. Check to make sure the
battery wand is secure.
CAUTION:
Be sure the cables do not become pinched
by the battery wand clips during installation. Damage or
overheating of components could result.
Tab
Slot
Cap
Latch
Battery
Wand
Squeeze
Place the socket
toward the motor end.
