Tenera Installation Instructions 73
Problem
The tassel cord and lower cord connector have detached from the upper cord
connector.
Solution
To Reattach the Tassel Cord:
■
Hook one side of the lower cord connector
to the upper cord connector.
■
Rotate the lower cord connector until it snaps
into place.
■
Twist the tassel cord to pull any stray cord fibers
out of the junction of the cord connector halves.
Stray fibers in the junction may cause the
connector to come apart.
Problem
The shading raises or lowers unevenly, the fabric rubs against one end of the
headrail, or the bottom rail is uneven when fully raised.
Solution
Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim to level, if necessary.
Adjust the bottom rail weight. See below.
Adjusting the Bottom Rail Weight
■
To release the weight clip, insert a flat blade screwdriver into the weight clip
and turn clockwise.
■
Move the weight in 1" increments toward the side where the fabric
is gathering.
■
Secure the weight clips in position by turning them
counterclockwise after making the adjustment.
■
Test and, if necessary, adjust again.
Weight
Weight
Clip
Weight
Clip
Fabric Roll
Move Weight
Upper Cord
Connector
Lower Cord
Connector
Snap in
Place
