Tenera Installation Instructions 8
■
Choose which set of holes works best in your application.
Mark the screw holes.
➤
The minimum depth required for mounting is 2" with a
battery wand and a back cover.
➤
Minimum depth is 1
1
/
4
"
with a satellite battery pack
and
back cover.
➤
Refer to the chart below for fully recessed depth
requirements.
IMPORTANT:
The front edges of the installation brackets must be level and aligned.
WARNING:
Failure to properly align the brackets could result in the headrail
releasing from the brackets.
■
Drill the screw holes using a
3
/
32
" drill bit.
IMPORTANT:
Use drywall anchors when mounting into drywall.
■
Use a level to check that the mounting surface is level. If necessary, you can shim the
brackets using the top tabs that were removed from the brackets.
■
If you ordered a back cover, attach the back cover brackets to
the installation brackets.
➤
If a satellite battery pack or DC power supply is used, first
remove the
top tab
from the back cover bracket.
➤
Snap the prongs on the back cover brackets into the
holes on the back of the installation brackets.
■
Attach the installation brackets using the screws provided.
IMPORTANT:
Do not overtighten the screws. Check to ensure the lever can be moved
easily side to side. If the lever is not moving easily, loosen the screws in
1
/
8
of a turn
increments until it can be moved easily.
Proceed to “STEP 2 — Install the Shading”
Minimum
Depth
See Chart
2" – 3"
Fully Recessed
Mounting Depths
Headrail
Battery Wand & Back Cover
4"
Satellite Battery Pack or DC Power
Supply & Back Cover
3
1
/
2
"
Installation
Bracket
Back
Cover
Bracket
Remove tab if using a satellite
battery pack or DC power supply.
