Kubota U50-5, Operating Instructions Manual

Page: 134 / 236

132
W9272-8135-1
05/2020
Operation

Press the auxiliary port enable switch (1) and turn on the auxil-
iary port function.
You will see the setting of the flow rates in the display. The bar
height "A" shows the flow rate at the respective auxiliary port con-
nectors (1, 2, 3 and 4).
If the bar graph is set to the lowest level (as shown in connector 3,
no bar obvious), flow is blocked and there is no oil flow.

Make sure that the flow rates are not set to the lowest level.

Rocker switch auxiliary port 1 (3) on the right control lever must
be pushed over completely to the right and left.
The auxiliary port connectors (1 and 2) are pressure relieved.
If the flow is blocked, the pressure cannot be relieved completely The hydraulic couplings at the aux-
iliary port connectors can jam as a result. Then connection or separation of the hydraulic cables of
attachments is not possible. Switch to a different mode, if available (page 126), or increase the flow
rate (page 127).
KX060-05_073
1 1