Kubota U50-5, Operating Instructions Manual

Page: 150 / 236

148
W9272-8135-1
05/2020
Operation
Refuelling the machine

Stop the engine.

Open the left service cover (page 156).

Remove the filler cap (1) by turning it anticlockwise.

Fill diesel fuel up to the base of the filler neck.

Screw on the filler cap and close the service cover.
Fill level monitor when refuelling
The momentary fill level during refuelling can be determined by means of an acoustic signal. For this, the starter
switch must be in the STOP position.
The switch (2) for the fill level monitor is located above the tank filter
neck (1).

Ensure that the starter switch is switched to the STOP position.

Press the switch (2).
The fill level monitor is enabled.
The following signals are output:
Interrupted signal

Tank is empty
Periodic signal

Tank is being filled
Continuous signal

Tank is full
Press switch (2) after refuelling to deactivate fill level monitoring.
The signal breaks off completely if the flow rate is too
low. As soon as there is enough fuel in the tank, the
signal restarts.
1 1
KX060-05_093
1 1
2 2
KX060-05_098