Kubota U50-5, Operating Instructions Manual

Page: 60 / 236

58
W9272-8135-1
05/2020
Assembly and functions
Description of the components of the right control console
1. Rocker switch for the auxiliary port 1
The rocker switch for auxiliary port 1 controls the oil flow to auxiliary port 1. Turning the rocker switch to the
left causes the oil to flow towards the connector on the left-hand side of the arm. Turning the rocker switch to
the right causes the oil to flow towards the connector on the right-hand side of the arm. Auxiliary port 1 can
be controlled proportionally (infinitely variable).
2. Horn switch
Depressing the horn switch activates the horn.
3. Auxiliary port enable switch
The auxiliary port enable switch activates the auxiliary port function.
4. Right control lever
The right control lever is used to move the boom and the buck-
et.

The figure, in conjunction with the following table, shows the
functions of the right control lever.
5. One way hold switch
Operating the one way hold switch results in a continuous oil
flow to the auxiliary port connector to the left of the arm. When
you operate it again, the oil flow discontinues. You can there-
fore operate an attachment without having to continuously hold
down the button.
6. Travel speed switch
Switches the travel speed mode on and off.
7. Dozer control lever
The dozer control lever is used to raise or lower the dozer. Pushing the lever forward lowers the dozer and
pulling it back raises it. Pushing the lever forward through the noticeable resistance moves the dozer into float-
ing position.
8. Heating and air-conditioner control (optional)
Operate the heater and the air-conditioner using the heating and air-conditioner control (optional).
Position of control lever Movement
1
Lower boom
2 Raise boom
3 Bucket crowd
4 Bucket dump
The attachment can move in an uncontrolled and sudden manner, there is a danger to life in
the working area!
When using accessories that are not suitable for continuous oil flows (e.g. Powertilt), using the one-
way hold switch poses a danger to life!
The auxiliary port cannot be operated proportionally with the one-way hold switch. The flow volume
is adjusted to the highest level in the factory.
- Before using the one-way hold switch, check that the accessory is suitable for use with conti-
nuous oil flows.
- Before using the one-way hold switch, make sure that nobody is in the working area.
- The flow volume of the auxiliary port must be adapted to the accessory.
1 1
3 3
2 2
4 4
KX060-05_030
STOP