5
START-UP
34
OPTIWAVE 1010
www.krohne.com
10/2016 - 4003537403 - MA OPTIWAVE 1010 R03 en
There are 4 buttons at the bottom of the Start
Start
Start
Start window: Measurements
Measurements
Measurements
Measurements, Analysis
Analysis
Analysis
Analysis, Diagnosis
Diagnosis
Diagnosis
Diagnosis and
Simulation
Simulation
Simulation
Simulation. You can use these buttons to do the tasks that follow:
•
Measurements:
Measurements:
Measurements:
Measurements: Monitor level and distance data. For more data, refer to
Measurements
window on page 35.
•
Analysis:
Analysis:
Analysis:
Analysis: Monitor change and rate of change in level, distance, current output, temperature
of the electronics and device status. It is also possible to monitor spectrum values. For more
data, refer to
Analysis window on page 36.
•
Diagnosis:
Diagnosis:
Diagnosis:
Diagnosis: Do a check of the device's condition (error messages etc.). For more data, refer to
Diagnosis window on page 38.
•
Simulation:
Simulation:
Simulation:
Simulation: Simulate measured data to make sure that the device operates correctly. For
more data, refer to
Simulation window on page 40.
5.3.2 Software installation
Equipment needed
•
A computer
•
One of these two solutions:
1
the DVD-ROM delivered with the device or
2
a high-speed
Internet connection
•
A web browser, if it is necessary to download files from the Internet
Software needed
•
Microsoft
®
.NET Framework 2.0 or a later version
•
PACTware
™
4.1 or a later version
•
Device Type Manager (DTM) for the OPTIWAVE 1010 radar level transmitter
This software is supplied on the DVD-ROM delivered with the device. It can also be downloaded
from the
“
Download center: Software
”
web page on the manufacturer
’
s website.
Installation procedure
1
Install Microsoft
®
.NET Framework 2.0.
2
Install PACTware
™
4.1 or later version.
3
Install the OPTIWAVE 1010 DTM on your workstation or your portable computer. Follow the
instructions in the Installation wizard.
4
Plug the HART modem into your computer (Serial or USB HART
®
modem). If you are using a
USB
®
HART modem, you must install the Driver for the USB HART
®
modem first. Make sure
that the location of the port for the HART
®
modem is clearly identified.
5
Start the PACTware
™
program.
i
End of the procedure.
