Maintenance Manual for J2 Sedan
Service
17
■
Oil rule should be used all the way to check whether the filling amount of engine oil is
proper.
7) Warm up the engine, check areas around the oil drain screw plug and oil filter for leakage.
8) Stop engine and wait for ten minutes.
9) Inspect oil level. See also “Engine oil level”.
8. Change Oil Filter
1) Dismantlement
①
Use oil filter wrench to dismount the filter.
Attention:
■
JAC original engine oil or equivalent product should be used.
■
Be careful not to be scalded since engine and oil are hot.
■
During dismantlement, a cloth should be prepared to wipe up the leaked or splashed oil.
■
Please keep the driving belt free from engine oil.
■
Clean any oil splashed on engine and vehicle.
2) Installation
①
Clear any foreign substance on mounting
surface of oil filter.
②
Paste a film of engine oil onto the oil seal
surface of new filter.
③
Tighten.
■
Tightening torque: 10-12N·m
Attention:
■
The engine oil filter must be tightened with a filter wrench.
■
Manual tightening may cause oil leakage due to the inadequate tightening torque.
3) Post-installation inspection
①
Inspect oil level, and fill engine oil when it is inadequate. See also “Engine Oil”.
②
Start engine, check for any oil leakage.
③
Stop engine and wait for ten minutes.
④
Inspect oil level, and fill engine oil. See also “Engine Oil”.
9. Replacement of Ignition Plug
Fig. 2.2.007
