Maintenance Manual for J2 Sedan
Mechanical Part of Engine
96
③
Loosen engine oil filler cap and remove the oil drain bolt.
④
Discharge the engine oil.
⑤
Install the oil drain bolt with new washer.
Attention:
■
Be sure to clean oil drain bolt and install with new gasket.
■
Tightening torque of oil drain bolt: 34-44N·m
⑥
Fill new oil.
Please refer to “Maintenance” for specification and viscosity of oil.
■
Oil volume: 3.8L
Attention:
■
Do not pull out oil gauge when filling oil.
■
The oil filling volume varies with oil temperature and oil drainage time, thus the above data
are only for reference.
■
Always use oil gauge to check oil filling volume.
⑦
Warm up engine and check the oil drain bolt and oil filter for oil leakage.
⑧
Stop engine and wait for 10min.
⑨
Check the oil level. Please refer to “Engine Oil Level”.
IV. Oil Filter
1. Dismantlement and Installation
1) Dismantlement
Dismount the oil filter with an oil filter spanner.
Attention:
■
Use original oil filter provided by JAC or equivalent.
■
As the temperatures of engine and engine oil are high, please proetct yourself from being hurt.
■
During dismantlement, prepare a cleaning cloth to absorb leaked or splashed oil.
■
Do not make the engine oil stick on drive belt.
■
Thoroughly wipe and dry the engine oil splashed on the engine and vehicle.
Fig. 1.2.005
