Maintenance Manual for J2 Sedan
Mechanical Part of Engine
95
①
Check oil level. Please refer to “Engine oil
level”.
②
Lift the vehicle, disconnect harness connector
at oil pressure switch and remove the oil
pressure switch.
③
Install oil pressure gauge and hose.
④
Start engine and warm up to normal working temperature.
⑤
Inspect oil pressure when engine operates with no load.
Note: The engine pressure will increase when the temperature of engine oil is low.
■
If there is obvious difference, please inspect oil circuit and oil pump for leakage.
⑥
Install the pressure switch in accordance with the following steps after inspection:
a. Remove any used sealant attached on pressure switch and engine.
b. Apply sealant as specified and tighten the pressure switch.
■
Please use the specified sealant: LT5699 or equivalent.
■
Tightening torque: 8-12N·m
c. After the engine is warmed up, make sure there is no oil leakage during normal operation of engine.
2. Change Oil
Attention:
■
As the temperature of engine oil is high, please protect yourself from being hurt.
■
Avoid direct contact of your skin with waste oil for a long time. If contact has taken place, wash
thoroughly with soap or detergent as soon as possible.
①
Warmup the engine to check engine compartment for oil leakage. Please refer to “Leakage of
engine oil”.
②
Stop the engine and wait for 10min.
Fig. 1.2.004
Fig. 1.2.003
