Maintenance Manual for J2 Sedan
Mechanical Part of Engine
97
2) Installation
①
Remove any foreign substances attached on
mounting surface of oil filter.
②
Apply a film of engine oil on oil seal surface
of new oil filter.
③
Tighten the oil filter until the O-ring seating
on the installation surface; tighten the oil filter
by more 0.75 lap or get the tightening torque
to 11 ± 1N • m.
Attention:
■
The oil filter must be tightened with filter spanner.
■
If the filter is tightened by hand, oil leakage may occur due to inadequate tightening torque.
2. Check after Installation
1) Check oil level. Please refer to “Engine Oil”.
2) Start engine to check whether there is oil leakage.
3) Stop engine and wait for 10min.
4) Check oil level and fill as required. Please refer to “Engine Oil”.
Fig. 1.2.006
