Maintenance Manual for J2 Sedan
Mechanical Part of Engine
100
assembly.
4) Install oil filter.
■
Clean the oil filter mounting surface on oil pump housing.
■
Apply some oil on O-ring of oil filter.
■
Tighten oil filter until the O-ring seating on the installation surface; re-tighten the oil filter by 0.75
lap or get the tightening torque to 11 ± 1N • m.
Attention:
■
The oil filter must be tightened with filter spanner. If the filter is tightened by hand, oil leakage
may occur due to inadequate tightening torque.
5) Install oil pan.
■
Clean cylinder block and oil pan mating surface to ensure that there are no oil and other impurities.
■
Apply sealant as shown in diagram below.
■
Specified sealant: LT5699 or equivalent.
Oil pan
Apply sealant
as shown in
figure.
Fig. 1.2.010
