Maintenance Manual for J2 Sedan
Electronic Control System
of Engine
185
the throttle. The resistance measurement shall vary linearly following the opening of the throttle.
The measurement on 2# and 3# pins shall be on the contrary.
Note: While observing the variation of resistance, pay attention to observe for presence of high
resistance leap.
Operating temperature: -40 - 125
;
℃
6. Dismantlement and installation of throttle
position sensor
1) Dismantlement
①
Disconnect the wire harness connector of air
throttle position sensor.
Note: Be sure that the ignition switch is at the
“Off” position.
②
Remove the screws of throttle position sensor
and remove the sensor.
2) Installation
Be aware of following to install with steps contrary to dismantlement.
■
Verify that the of the wire harness connector is inserted securely.
■
Tighten self-tapping screw.
IV. Crankshaft Position Sensor
1. Component Description
The crankshaft position sensor is used to provide the engine speed information and crankshaft top
Fig. 4.3.07
Fig. 4.3.08
