Maintenance Manual for J2 Sedan
Mechanical Part of Engine
125
■
The Y-ring must fully fit with fuel tank during installation.
■
Tilt the fuel pump to facilitate its installation and pay attention to its direction.
■
There should be no turn-up on Y-ring during the installation.
■
Pre-tighten the locknut during its installation, and then tighten it horizontally.
2) Connector
Insert the connector of fuel supply hose with following methods:
①
Check the connection for any foreign substance and damage.
②
Make the connector align with the resin pipe and insert the connector straightly until “click” is
heard.
③
Check whether the connector is properly connected with following methods after connected.
■
Visually check whether the 2 raised positions have been connected to the connectors.
■
Stretch the resin pipe and its connector hard and make sure they have been firmly connected.
4. Check after Installation
Check for fuel leakage with following steps.
1) Set ignition switch at “ON” position (when engine stops), and then check the connection of fuel
pipe for leakage.
2) Start the engine, increase its speed and recheck the connection of fuel pipe for leakage.
