Maintenance Manual for J2 Sedan
Service
21
weight is nearest to the calculated value, and install it to the specified outer side position, or at the
specified angle relative to wheel.
Attention:
■
The balance block of outer side should be installed before inner side.
■
Prior to the installation of balance block, fitting surface on wheel must be thoroughly
cleaned.
a. Install the balance block to the position indicated in figure below.
b. As shown in the figure, during installation of
balance block on the wheel, the balance block
should be placed in the groove area on the
wheel inner wall, and fix with its center
towards the position (or angle) indicated by
the wheel balancer.
Attention:
■
The balance block should not be reused; it should be replaced every time.
■
At most three balance blocks are allowed to be installed.
■
The original balance blocks should be used any time.
c.
In case the calculated weight of balance block
is more than 50 g, the two balance blocks
should be installed in a line.
Attention:
■
Never install a balance block on another
one.
③
Restart the wheel balancer.
④
At position (or angle) indicated by the wheel
balancer, knock in the balance block at the
inner side of wheel.
Attention:
■
At most two balance blocks are allowed to be installed.
⑤
Start the balancer. Make sure the residual unbalance value of both inner side and outer side is only
5 g or less.
■
In case the residual unbalance value of either side is more than 5 g, please repeat the installation
steps for balance block.
Fig. 2.2.010
Fig. 2.2.011
Stuck weight
Towards the
groove
Position (or angle) indicated
by the wheel balancer
Center of gravity
Position (or angle) indicated
by the wheel balancer
