Maintenance Manual for J2 Sedan
Overview
6
Section III Lifting, Protection and Towing of Vehicle
I.
Lifting of Vehicle
1. Vehicle’s Supporting Points
The positions of vehicle’s supporting points are shown in figure below.
Attention:
Don’t lift the vehicle by using the point other than those specified; otherwise vehicle body
may be damaged.
Positions of Vehicle’s Supporting Points
2. Operation of Lifter
The lifter should be operated strictly in accordance with the specifications of manufacturer.
Caution:
The operation against the specifications may cause damage of vehicle or personnel injury or
even death.
II. Protection of Vehicle
1. Appearance Protection
Be sure to use the four protection appliances including seat cover, steering wheel cover, gearshift
lever cover, and foot mat before any operation. A protective pad must be applied on the fenders
when engine hood is opened for inspection.
2. Preventive Measures before Welding
Since electrical components are installed on the vehicle, the following procedures must be carried
out in order to avoid too large current through such components in welding:
1) Turn ignition switch to “OFF” position;
2) Disconnect negative pole of battery;
3) Ground the welding equipment carefully at a point nearby the welding area;
4) Cover other exposed equipment around the welding area to prevent solders from splashing on.
Supporting point
